I am having a hard time trying to figure out how to only display one FID signal on a report from a dual injector GC system in OpenLAB 2.4. The calibration that was run used the dual injector setting, but when we were running test samples we only need to run one injector. When we go to process the data for the samples, the report displays both the signal from the front FID (FIDA) and back FID (FIDB). We only need to display the results from FIDA as there were no samples run on FIDB. I know when we have run a calibration using both FIDs we are able to sort the signals by the injector and it will then only display one FID on the report. I am unsure why it will not display only one FID on the report if we only analyzed samples with one FID. Any help is appreciated.