Integrating only 1 TIC in a data file with 2 TICs

Question

Our lab just got a GC/MS-FID installed and we are using MSD Chemstation data analysis instead of mass hunter. However, is there a way to only integrate the GC-FID tic and not the tic used for mass spec? (I hope that makes since) Or is it set up to integrate all GC tics in the data file? (Again, hopefully that makes since!)

See attached file. Sorry for the red markings on the top!

Thanks!

Alyx

ron_tackett · Accepted Answer

In data analysis, under the File menu, Select Signals and turn off the data.ms. You can also unlink the signals during acquisition so each signal is in its own data file.

Integrating only 1 TIC in a data file with 2 TICs

Top Replies