Biotek Synergy HT microplate reader

Hi all. I am trying to run the kinetics of catalase decay against H2O2 using 240 nm absorbance. I am using Biotek Synergy HT microplate reader and Gen5 software. I need the kinetics every second or 15 second at maximum for 2 minutes. I am not able to adjust the time to get reading every 15 second. It gives an error message something like the time limit selected is not possible. So, my question is whether the device is not able to give reading every 15 seconds or is there any mistake with my protocol? Thanks in advance.

Was this helpful?