I tried to copy EIC Signal description items near each other and I don't know how to avoid this problem showed below.
As you can see, the three chromatogram is the same compound. How can I avoid this repetition?
thank you for your help.
Find maintenance, best practice, and troubleshooting articles.
I tried to copy EIC Signal description items near each other and I don't know how to avoid this problem showed below.
As you can see, the three chromatogram is the same compound. How can I avoid this repetition?
thank you for your help.
Compound amount is calculated directly by the curve. Concentration adds multipliers or dilution factors based on what we have selected.
It's not the sample amounts that will be zero but the SAMPLE weight. And I put sample weight only for samples.
Where is this "Sample Weight" in the injection list? I don't have that field and I doubt it defaults to 1. I can't find it, but the formula still works for me
you can see it in the injection list.
So I may be able to calculated my multiplier by adding 1 in all row but it's weird and I will have question from quality revisor because in fact, I didnt weight 1 mg of samples.
I don't see "Sample Weight" here? I can see a "Sample amount" but that's exactly what I was talking about where all of mine are 0. Was the photo cropped wrong or are we getting our wires crossed?
I only add mg amount in sample injections. For example if I weight 25.00 mg of cannabis concentrates, I will add it into the good row for this sample injection.
Okay, sounds like we got our wires crossed. On my side, having 0 in the "Sample amount" field causes no problems. Try the formula in your table =Compound_Concentration/Compound_Amount