Is there a way to disable a signal for all the samples in a sequence in Chemstation C.01.10? I have UV and MS data but the UV is backup and I want to not see the UV data in the entire sequence unless I need it.
I added tags to this post to increase visibility.
You could remove the DAD signal from your sequence method's signal details table (accessed by going to Calibration>Signal Details):
Then you can update your preferences to load using signal details, so that whenever you load data it will only load the signals that are defined in the signal details table. To access this preference go to View>Preferences:
NOTE: If you remove a signal from the signal details table it will also remove the signal from your method's calibration table.
Retrieving data ...