How would can I integrate from valley to valley in the integration events table? I have never had to adjust the baseline of a peak after data acquisition any time. This is for CE Chemstation.
Thank you in advance!
What revision of OpenLab ChemStation are you running? You can determine this by going to Help>About.
It would be helpful to see what your method's integration events are already set to. Could you post a screenshot of the current integration events in your method? I usually prefer to try to correct integration on the method first before resorting to manual integration, but manual integration is an option if you would prefer to go that route instead.
This the Version of ChemStation we are using.
This is the integration events. I usually do not do manual integration as the integration is set in the method. However, I am not sure how to "correct" integration in the methods. How would i go about doing this?
Thank you again.
One thing that might help in your integration parameters would be to switch the Baseline Correction from classical to Advanced.
You could also try adding in a Baseline at Valleys On timed event just prior to the peaks in question to see if that works for you.
I tried to change the baseline correction from classical to advanced, and the main peak 1 looks OK, but the peak beside that doesn't. Will this be acceptable?
I can't really tell you whether a peak's integration is acceptable or not. All I can help you with is how to use the integration tools available in the software.
Retrieving data ...