Thank you for helping me.
For future reference, it would be much appreciated it you provided the software product and revision in your problem description. From the screenshot you included I can see that you are using OpenLab CDS, but it would also be helpful if you could tell us the revision of OpenLab CDS you are running. This can be determined by going to Help>About.
If you wish to open data files for the completed injections in a currently running sequence, then you will need to launch a Review Data Analysis session by selecting the 'Review Completed Injections' option outlined below:
Please note that while the Review Data Analysis session is open, the following runs in the sequence will continue to acquire; however, the results will not continue to be processed. The runs will remain with an 'Acquiring' status until you close out of Data Analysis or until Data Analysis automatically shuts down (occurs after sitting idle for 30min). This also means that pending items in the Run Queue will not be able to run until Data Analysis is closed, as this sequence item will not complete until all the injections can be processed.
I used Agilent OpenLab Data Analysis - Build 22.214.171.1241, version 2.4
Yes, that's my problem as long as the thigh continues and the data analysis is open and The runs will remain with an 'Acquiring' status.
This is the expected behavior so it is important that you remember to close the Review Data Analysis session in a timely manner so that it does not hold up the Run Queue.
thank you very much ryoboyle.
Retrieving data ...