Hi, is there a report field that will show the number of data points which have been taken across the peak signal. I'm using OL 2.3
I updated the tags on this post to increase visibility.
Unfortunately, there is not a built in field that can be used in OpenLab CDS Reporting that will display the number of data points collected across an integrated peak. The only place I know of in the software that would display this would be the Peak Similarity Curve for spectral data with an impurity check setup in the method:
You can also setup a calculation to approximate the number of data points collected across a peak by multiplying the data collection rate (set in the detector acquisition method) by the peak's base width (converted to seconds).
I did the calculations for the values given in OL2.4 with a DAD, and the data acquisition rate is set to have 30 acquired points for the smallest peak of interest.
Retrieving data ...