From intelligent report for a sequence report,how can I add a chromatogram for a single DAD channel (not all channels at once)
Thanks alot !
What revision of OpenLab EZChrom are you running? You can determine this by going to Help>About.
Thank you very much,but finally succeeded by myself.The version is A.05.06 (see picture) and now I have other challenges if you can help me.How can I bring formula and the other specific parameters for calibration curves in Inteligent report. I finally managed to reach the stage where it can be seen in the attached picture.
Since you already asked this question in a separate post, I will mark this question as assumed answered.
Any discussion on the above reply should be directed here: Intelligent Report -values for a calibration curve- how do they can be shown
Retrieving data ...