7 Replies Latest reply on Dec 19, 2018 10:31 PM by mr.white

    Problems with Dilution Factor and Multiplier




      I got the problem that the dilution factor and the multiplier are completely ignored by the Software. We are using OpenLabs 2.1


      first I setup the factors in the "Data Analysis"

      then "Reprocess all"

      Then select reporting and choose my favourite Report. Refresh again and click on Preview.


      The Standard Solution got around 5 ppm. The Sample is 1/10 dilutet, due do high concentration.

      Even if I put 1/100 on dilution factor and multiplier at the same time, the result stay at 5mg. It supposed to be around 50ppm..

      Anyone know what went wrong.

      Thank you