I'm using chromeleon software on a 1260 infinity II. I cannot get the software to recognize the position of a needle wash vial and have been unsuccessful in setting up any type of needle wash using a vial. Can anyone help?
I got it figured out...its a naming scheme thing. It's a bit strange because when you make a sequence the position numbering for the sequence is always something like P1:A1, but for the needle wash, the naming sequence, within the same software, is something like P1-A-1. So weird!
It is part of our driver, but if I don't know if it was added to Chromeleon. I am checking with our factory. You may also need to check with Thermo.
What version of Chromeleon do you have?
thank you! This is useful information.
Retrieving data ...