5 Replies Latest reply on Nov 2, 2017 7:11 AM by spacefish

    Could not open channel RD - Signal to Noise Test

    jmarshall

      Hello,

      We've had some problems with noise on our detectors, so we ran the drift and noise test, but it pops up with an error.

      It did run a couple of times but then stopped working.

      I tried it on another system with the same software and it also had this problem (see below)

      .Version B.02.03(64) G1315B

      Labadvisor.jpg

      Any help would be greatly appreciated.

      Thanks Joe