Help - Cross-Sequence Report OpenLab CDS

Hello,

I am not sure what your exact question is on the issue. The first step is to create a report that is setup as a cross-sequence summary. I do not believe any of the canned reports are setup as cross-sequence summaries. You can check an existing report by looking at the properties of the report. Please note you cannot change this setting once the report has been created. 

Thank you very much for your feedback. It helped a lot.

But I have one more question:

Is it possible to fix information in the report?

For example, a table that should be repeated in all reports.

Is there any way I can do this?

Hello,

I am not sure I understand the question. If you are asking, can you change an existing report to repeat at a different level once created, then no you cannot repeat at a higher level than the report configuration. If you start with a cross-sequence summary you can set objects to repeat as needed per injection, per sequence, compound, ect. The cross-sequence summary has no built in repetition.   

Marty

Hello,

I am not sure I understand the question. If you are asking, can you change an existing report to repeat at a different level once created, then no you cannot repeat at a higher level than the report configuration. If you start with a cross-sequence summary you can set objects to repeat as needed per injection, per sequence, compound, ect. The cross-sequence summary has no built in repetition.   

Marty