Help - Cross-Sequence Report OpenLab CDS

Hello everyone, I use OpenLab CDS 2.5 and I'm starting to develop an Intelligent Report for my analyses. I need to generate a Cross-Sequence Report to use results from different sequences in the same report. For example, my calibration curve is in one sequence and the samples in another, but I want to show a table with both things in the same report. I've tried to do it in several ways but I couldn't. I looked for references from Agilent but I also didn't find anything that guides me on how to do it. Can anyone help me?

Top Replies

martin.adams 5 months ago +1 verified

Hello, I am not sure what your exact question is on the issue. The first step is to create a report that is setup as a cross-sequence summary. I do not believe any of the canned reports are setup as…

Parents

+1 martin.adams 5 months ago

Hello,

I am not sure what your exact question is on the issue. The first step is to create a report that is setup as a cross-sequence summary. I do not believe any of the canned reports are setup as cross-sequence summaries. You can check an existing report by looking at the properties of the report. Please note you cannot change this setting once the report has been created.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Reply

+1 martin.adams 5 months ago

Hello,

I am not sure what your exact question is on the issue. The first step is to create a report that is setup as a cross-sequence summary. I do not believe any of the canned reports are setup as cross-sequence summaries. You can check an existing report by looking at the properties of the report. Please note you cannot change this setting once the report has been created.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Reject Answer

Cancel

Children

0 DSVicente 5 months ago in reply to martin.adams

Thank you very much for your feedback. It helped a lot.

But I have one more question:

Is it possible to fix information in the report?

For example, a table that should be repeated in all reports.

Is there any way I can do this?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 martin.adams 5 months ago in reply to DSVicente

Hello,

I am not sure I understand the question. If you are asking, can you change an existing report to repeat at a different level once created, then no you cannot repeat at a higher level than the report configuration. If you start with a cross-sequence summary you can set objects to repeat as needed per injection, per sequence, compound, ect. The cross-sequence summary has no built in repetition.

Marty
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?