Add UV confirmation range to a report in OpenLab CDS 2.4

Question

We use UV confirmation to positively identify analyte peaks in a sample by comparing to a reference standard. 
 I would like to know if there is any way to get the wavelength range over which the comparison was done on a report. I see "Spectra Confirm Match Factor" and "Spectra Confirm Result", but no option for range. 
 My concern is that the analyst could change the comparison range to be very narrow which may result in a better match than if they had used the entire spectrum. Having the range on the report would make this very obvious.

martin.adams · Accepted Answer

Hello, 
 
 The way I have done it in custom reports is to add single data analysis method parameter for the 4 values that make up that setting. You could just add the low and high range values if you do not need the yes no for the use. You could also add full sections of the DA method if you do not want to work with the single fields. 
 
 Marty Adams

Add UV confirmation range to a report in OpenLab CDS 2.4

Top Replies