Trying to add autotune information and parameters, specifically step size, to the report template. I am using Agilent 1290 LC with 6135C MS.
Find maintenance, best practice, and troubleshooting articles.
Trying to add autotune information and parameters, specifically step size, to the report template. I am using Agilent 1290 LC with 6135C MS.
Hello,
No the tune report is created by the MS driver and only accessible as a PDF from the DA session. These values are not stored in the ACAML and thus are not readable by IR.
Marty Adams
Hello,
No the tune report is created by the MS driver and only accessible as a PDF from the DA session. These values are not stored in the ACAML and thus are not readable by IR.
Marty Adams