How to change signal

Apologies if the answer to this is simple, but I am new to Openlab CDS and I am still trying to get to grips with it

I have set up processing and acquisition methods using Openlab and below is an example of a run - at the top of the chromatograph, it shows the signal FID1B

however if I import  the raw data from a run carried out on our previous software (EZchrom) it gives me the following - at the top of the chromatograph, it shows the signal 'Backsignal'

All my new methods and calibrations show the FID1B signal and the software wont allow me to process the imported data because it uses a Backsignal.....have I missed something really obvious or is there a way around this as I would like to reprocess all my old data using the Openlab software

Many thanks 

Parents Reply Children
Was this helpful?