How to display calibration graphs with overlap bracketing mode?

I am using Agilent OpenLAB Data Analysis - Build 2.203.13.17.

I have some data with overlap bracketing mode (Cal-Sample-Cal-Sample-Cal). I am struggling to display a calibration graph for each bracket in the report. I only managed to display the last calibration graph but not both in the report.

Parents
  • Update: I tried using =CalibCurve_LastModifiedDate on the Group repea but it is generating 3 calibration graphs (1st bracket graph, then 2nd bracket graph, then 1st again).

  • Hi

    Sounds like you have a sequence summary report.  Does the Calibration curve summary snippet not do what you want?  That should pull out just the graphs for the samples inside the brackets.

    You may have to find some other filtering to pick out specific calibration curves.  One thing you could think about is using Sample Labels and using these as a repeat/filter for the calibration graphs.  Which version of OpenLab CDS 2.x are you using?

    /Andy

Reply
  • Hi

    Sounds like you have a sequence summary report.  Does the Calibration curve summary snippet not do what you want?  That should pull out just the graphs for the samples inside the brackets.

    You may have to find some other filtering to pick out specific calibration curves.  One thing you could think about is using Sample Labels and using these as a repeat/filter for the calibration graphs.  Which version of OpenLab CDS 2.x are you using?

    /Andy

Children
Was this helpful?