Can't get calibration curve in OpenLab CDS 2.6


Very recently had initial training in OpenLab CDS.  I'm unable to get a calibration curve for data analysis for measuring samples.

In Processing Method, I've filled out the calibration levels etc from the compounds menu, but can't figure how to get a curve generated from this.  In Calibration Curve, where the curve should be, there's just a "Not Quantified" message, and where the calibration table should be "No calibration data available".

I'm sure it's just a case of pushing the right few buttons, but cannot figure it out.

Much appreciated,


Parents Reply Children
No Data
Was this helpful?