Showing Manual modifications in report (OpenLab CDS Plus 2.6)


In OpenLab CDS Plus 2.6 i'm using the Sequence Summary Report (extended) template to show my results. The print screen below shows a section of it where i'm having as issue.

Every time i do a manual modification for one of the peaks, it shows as if i did manual modification for all the peaks in that injection. In the example below the table is showing "ManualCompoundID" for all the peaks, but i only carried out Manual Identification for one of the peaks (the FLD signal which is saturated).

How can i change the table so that it identifies only the peaks that were actually manually modified ?

Thank you,


Was this helpful?