calibration compound amount calculation

Question

Is it possible for the processing method to calculate the calibration compound amount if the analyst enters the sample amount, purity, and dilution factors in the injection list table, or does the calibration compound amount need to be entered in the compound amount column?

Andy Wright · Accepted Answer

Hi ADoud 
 I'm not sure that I understand the question, but I'll try to answer anyway 
 
 The amount of each level for calibration standards needs to be entered in the Calibration table in Data Analysis. If you want to correct for purity of the standard, then you can use the multiplier column in the Calibration table too. 
 Sample Amount is not relevant for standards, since it primarily used for mass% calculations. 
 It IS possible to put the amounts of the standards in the Compound Amounts section below the sequence table in data acquisition. 
 
 Was that the question? Is this the answer? 
 /Andy

calibration compound amount calculation

Top Replies