ChemStation did not complete its initialization cycle

Hi,

I have a problem with GC-MS system. Its a 7820A GC and 5977E MS. I get an error saying "ChemStation did not complete its initialization cycle " when I try to start the run program. Then it just shuts down and creates a log file (attached). I can also see in the message bar that the GC is offline. The MS display says "VascFault".  I have re-installed and updated the Chemstation software and the IP addresses are correct. Does anyone have any tips on how I can solve this? I would be very grateful. Im quite new to GC-MS, sorry if I have left out any key information.

Best,

SSE


icstart1.log

Was this helpful?