Partial Sequence; Results Report; IR Template; OpenLab C.01.06

Question

Hello everybody,

I wanted to reprocess part of the recorded chromatograms and printed out only the results from the selected chromatograms on an IR template as PDF.

The report name was specified in the "Summary report Name" of the "Sequence output".

I selected the chromatograms in the table partial sequence and processed them. The created PDF file contained the complete chromatograms of the sequence run, but not the selected ones which I would like to get.

Thanks for advice

Best regards

Mr.hbar

OpenLab-Chemstation C.01.06

martin.adams · Accepted Answer

Hello, Why would you not use the review mode in Chemstation? You should be able to create your reports for select injections in one dataset or multiples in the review mode without and reprocessing needed. In your version, only a few of the live system values are not available when the report is created in review. Those values only apply if you have a backend content manger like ECM. Only ff you needed that information would I suggest creating the report by using a partial reprocessing. In the review mode you can select the runs you want from your datasets and apply any IR reports you would like to create. Marty Adams

mr.hbar · Answer

Hello Marty, 
 I have created a couple of IR templates capturing the complete data processing at our lab. Entries, like sample name, weighing amount and those of the refering ref.standard, were necessary to fill in at the analysis start. Analytical results are presented on the report in the appropriate formate and design for the subsequent use, e.g. for creating the certificate of analysis. No more calculation with external software, e.g. Excel, is necessary. 
 The data processing is not able to be conducted by the proposed way using the Agilent templates. 
 The templates muss be protected against uncontrolled changes, ideally by password. Would that be possible ? 
 The OpenLab C.01.06 is operated under Windows 7. No password protection of the IR template folder is possible without installing an external software which is no option for us to do this. 
 I notice that only those IR templates which are stored in the folder C:\ChemStation32\Reportstyle are able to be chosen in the sequence output for result reporting. Is it possible to switch to other folders for browsing the templates ? ideally from the ECM. We have the software installed. 
 The templates have benn modified several times after the first creation. The audit trail tracks the changing by increasing the version number. How can I re-start with version numberring 01 when the template is implemented fort he routine use. 
 Thank you for ideas and comments. 
 Best regards mr.hbar

Partial Sequence; Results Report; IR Template; OpenLab C.01.06

Top Replies