GCMS sequence is halting in the middle of the sequence.

Error states "Sequence error or user abort. Sequence Halted. To resume, re-run the sequence". Nothing has changed other than locking down the method. It will run part of the sequence, (sample then clean run) but it always stops at a clean run randomly in the sequence. I have to restart the computer, and restart the GCMS, then I can pick the same sequence back up where I left off. never done this before. GC-6850, MS-5975

 

Example:

blank

sample

clean run

blank

sample

clean run

blank

sample 

clean run------> error

Was this helpful?