When the MSD is turned on, it gives this error that I cannot find information anywhere. Anyone know what that is?
Find maintenance, best practice, and troubleshooting articles.
Hi faith,
More than likely the msd smart card is hung. With the software off you can press the menu key on the front of the MSD until you see controller , press item , then press yes at restart. Once the controller restarts, try again and you should be ok to collect data. This problem most often happens after a filament blows mid run.
If the above doesn't work, power cycle the msd. I hope that helps.
Hi faith,
More than likely the msd smart card is hung. With the software off you can press the menu key on the front of the MSD until you see controller , press item , then press yes at restart. Once the controller restarts, try again and you should be ok to collect data. This problem most often happens after a filament blows mid run.
If the above doesn't work, power cycle the msd. I hope that helps.