Cary UV3500: How to pause during measurement or change graph settings in the report.

Hi All,

We are working on a kinetic method on the Cary UV 3500. But are facing some small problems. First of all, we measure the signal before and after addition of the substrate but the stirring function does not seem to work sufficient enough to mix it. We therefore take the cuvet out and manually mix before placing it back. This works but removing the cuvet results in sharp peaks so ideally we would like to pause the measurement, or alternatively we would like to have the zoomed in trace on the report, but we cannot find how to alter the plot settings in the report.

Thank you in advance.


Was this helpful?