My lab has recently installed an Agilent 8890 GC system. This has been set up to analyze for EBDs, TCPs, and DBCPs. When viewing samples in Agilent's Environmental Data Analysis, in the QEdit window, the baselines for each sample start below 0 on the Y-axis anywhere between -15000 to -35000. This causes quite some effort when trying to locate peaks early in the run time of samples, having to resize the window to locate the peak we want to manually integrate if we need to. Is there a way in which we can adjust the lowest Y-axis value to be lower than our negative baseline so that is visible without needing to manually zoom in.
