Hello, I am currently using the Report Builder for mass hunter and do not quite understand how to use data binding. I have been trying to modify the provided templates to get what we need in our lab reports, but I am having some issues. If possible, is there some place to learn the basics of data binding? I looked through "Quantitation DataSet" document that was linked in other questions similar to mine, and I could not quite understand how to apply the data binding concept to the report builder. I have no trouble modifying the data binding and navigating the software, I just am not sure how use data binding within the software. I have a report editor file which I will upload so others can see. In this file, I would like to have the calibration data for each compound along with each individual peak data such as: calculated concentration, percent recovery, and retention time. Currently, I can obtain all of the information I need, but extra lines in each table are added and each extra line causes the data to line up incorrectly (I imagine I am binding the data incorrectly). My main concern is learning the basics of data binding so I can begin to change the report formats myself.