Hi,
We have been told this lamp does not require a technician to install it. However we can't seem to find instructions on instruction manual on how to replace the lamp?
Thank you
Find maintenance, best practice, and troubleshooting articles.
Hi,
We have been told this lamp does not require a technician to install it. However we can't seem to find instructions on instruction manual on how to replace the lamp?
Thank you
Hi
Please check above description..Might need service call...
Thank you for your support
Yes, you will need on-site service to replace the lamp. Should say- a service engineer is needed.
Hi....We have some Agilent 1260 FLD identifiers (G1321B) at various areas. I have changed the light at one area. The screws were difficult to eliminate to get to the trigger pack yet it was possible. I went to one more site to change the light and after the 5 screws were eliminated, I was unable to not eliminate the cover. Any ideas?
I don't really get the question, but replacing (and adjusting) the lamp requires a trained engineer and access to the service manual. If an untrained person works on the Xe-lamp or FLL/trigger pack, damage can be done and definitely a loss in intensity is to expected.