there is no accessible container available location error at Agilent 1260

Hi

Pls check page# 35 onwards in above attachement.

Either some driver like Agilent LC RC.net is missing or method problem.

Reprocessed complete entire method then after make sequence and see...

Hope, it will help you...

Thanks for your fast feedback

Where I can find  Agilent LC RC.net  driver?, as I can't able to make any sequence or run any samples on Agilent ALS 1260

Check in software cd..

Which version of openlab chemstation u r using.

Did you try to edit entire method then after sequence making.

Can you see modules of hplc in chemstation in green color...

I use OpenLAB CDS ChemStation Edition Revision - C.01.06

I think, that I can't able to enter "Sample location" for Agilent 1260, Due to missing Driver, so Is this driver include in installation CD?, or may need some configuration of well plate of 1260 sampler

I tried to make new method, and load methods, but noway, and I can see all modules, either pump , autosampler, detector with green light, and only problem is to adjust sample plate location..

so, Any suggestions please..

Hello sherifv4,

Do you try to assign the correct well plate on your sampler? 

Hi sherifv4

Please advise if you are still having the issue and if you have tried assigning the correct well plate on your sampler