Delay volume calibration for the open-bed fraction collector G7159B

I am trying to calibrate the delay volume for the G7159B fraction collector. I clicked on the "perform delay calibration run" in the ChemStation software, following the instructions given in www.agilent.com/.../G7159BUser.pd. It goes successfully through all the steps. I then  select "Start calibration run" and waited for about 10 min. Nothing seemed to be happening. The standard sample was not being injected. Could anyone suggest what I could be doing wrong.

I have also tried to use Lab advisor (version B.02.12) but it does not give the chance to select the autosampler, only manual injection.

Was this helpful?