Delay volume calibration for the open-bed fraction collector G7159B

I am trying to calibrate the delay volume for the G7159B fraction collector. I clicked on the "perform delay calibration run" in the ChemStation software, following the instructions given in It goes successfully through all the steps. I then  select "Start calibration run" and waited for about 10 min. Nothing seemed to be happening. The standard sample was not being injected. Could anyone suggest what I could be doing wrong.

I have also tried to use Lab advisor (version B.02.12) but it does not give the chance to select the autosampler, only manual injection.

Parents Reply Children
No Data
Was this helpful?