How to check leak sensor of Agilent Hplc?

Question

Hello

Is there any way to measure or check Agilent leak sensor to know if it work good or not?

Also, Is there any way to ignore the leak sensors by disconnect it from PCB or if there any way to not use leak sensor in Agilent LC 1260?

So, any suggestions...

Admin · Accepted Answer

This question has been marked as assumed answered.

sschombu · Answer

The leak sensor usually gets warm when the module is on. To test it, either put a few drops of IPA on it (and dry it off thoroughly when done) or blow on it with compressed air. Leak sensors cannot be turned off, it´s a safety feature. The only exception that comes to my mind, might be a certain version of the TCC and possibly MCT, so column compartments. Here switching off the leak sensor might be beneficial in case you have heavy condensation inside the column compartment.

How to check leak sensor of Agilent Hplc?

Top Replies