GC/MS

Forum Hello the autotune is stopping the filament switching on and off twice then HED MS fault appears. What can i do?

Hello the autotune is stopping the filament switching on and off twice then HED MS fault appears. What can i do?

Mg7 over 1 year ago

Hello

Autotune is stopping

Filament switch on and off twice

HED fault appears

Binary operator - is not defined for left operand type scalar array and right operand type scalar array

What is the problem?

What can i do?

Please help

Thank you

Parents

0 paulsalverda over 1 year ago

What is the vacuum? When the filament turns on - is it super bright -- which could signal a big air leak?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 paulsalverda over 1 year ago

What is the vacuum? When the filament turns on - is it super bright -- which could signal a big air leak?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Mg7 over 1 year ago in reply to paulsalverda

Yes it is bright , i will verify first

Thank you
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?