GC/MS

Forum New Gc/MS

New Gc/MS

Rashad over 2 years ago

A New GC/MS was installed in our lab .GC 7890A with MSD 5975C but Run mode is always on control panel with or without software control .

Top Replies

well over 2 years ago +1

TRAY to install the new fresh copy of software

Parents

0 paulsalverda over 2 years ago

The LCP status messages are on page 53-57 in the 5975 Operations Manual which can be found at: 5975 Series MSD Operation Manual (agilent.com)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 paulsalverda over 2 years ago

The LCP status messages are on page 53-57 in the 5975 Operations Manual which can be found at: 5975 Series MSD Operation Manual (agilent.com)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Rashad over 2 years ago in reply to paulsalverda

Hi, Even without MSD and without Auto-sampler the status on Gc is Run in progress
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?