We have a 5975C so you can see the filaments glow. Have you ever seen a filament go off and on during a run? When a filament goes bad it is dead but I've never seen this before. The other one is bad so I'll have to open it up.
Find maintenance, best practice, and troubleshooting articles.
We have a 5975C so you can see the filaments glow. Have you ever seen a filament go off and on during a run? When a filament goes bad it is dead but I've never seen this before. The other one is bad so I'll have to open it up.
Yes! You replaced it and you know it's bad, but I bet it is broken and when it heats up, it turns off, cools down, makes contact again and then cycles that way.
Also, you may have to vent and replace the filament even if only one breaks:
Yes! You replaced it and you know it's bad, but I bet it is broken and when it heats up, it turns off, cools down, makes contact again and then cycles that way.
Also, you may have to vent and replace the filament even if only one breaks: