After cleaning the source and pumping down the 5973 will not reload and gives the 24 and 26 error codes. I have to reboot the computer to fix the problem.
After cleaning the source and pumping down the 5973 will not reload and gives the 24 and 26 error codes. I have to reboot the computer to fix the problem.
found these for you through...
tune and Vacuum control > status > MS error codes
So looks like, if the error was not there before the source change, that there maybe an issue with the filaments.Does the turbo pump reach 100% and what does the vacuum go down to? How many Torr?
Error code 26 shows there is an issuewith the HED, potentially, but I suspect it is something different as this error normally only shows up weither during sample runs or tuning.
found these for you through...
tune and Vacuum control > status > MS error codes
So looks like, if the error was not there before the source change, that there maybe an issue with the filaments.Does the turbo pump reach 100% and what does the vacuum go down to? How many Torr?
Error code 26 shows there is an issuewith the HED, potentially, but I suspect it is something different as this error normally only shows up weither during sample runs or tuning.