7697A to 7890B connection

We recently obtained a 7697A Headspace Sampler for a 7890B GC. The sampler is used and I'm not sure we received all that is necessary to connect it to the GC. We have a vertical bracket and clamp to hold the transfer line above the GC inlet, but nothing for the connecting interface. I was hoping someone could point to the items needed for the interface and/or a picture of this connection. 

Parents
  • Normally the connection is done through the ethernet ports of the devices. So all you need is a LAN-switch and 2 LAN cables.

    Which chromatographic system are you using? If if is MassHunter, you can enter the IP addresses in the Agilent GCMS Configuration Launcher and accordingly at the GC/HS using the devices keyboard under Options/Communications.

Reply
  • Normally the connection is done through the ethernet ports of the devices. So all you need is a LAN-switch and 2 LAN cables.

    Which chromatographic system are you using? If if is MassHunter, you can enter the IP addresses in the Agilent GCMS Configuration Launcher and accordingly at the GC/HS using the devices keyboard under Options/Communications.

Children
Was this helpful?