Not Ready

Markw 11 months ago

The LED display on the front of the GC says "Status Ready" but on the monitor it says "Not Ready" in the yellow bar. If I try to run a sequence it turns blue "Sequence Running" for a few seconds then yellow "Sequence Stopping". I have a 7820A GC running off Chemstation software.

0 Mohammad 11 months ago

first try an other method

if it works normally check your parameters, maybe injection source is manual not ALS

also monitor your gases and pressures and make sure thar the flame is ON

sometimes the inlet can'treach the pressure

or the makeup flow is too high

...

if you see that every thing is OK try to create a new method
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Was this helpful?