Hello all,
Trying to figure out where or how to change ALS configuration on the touch pad from Front Injector to Back Injector and vice- versa?
Thanks,
Ting
Find maintenance, best practice, and troubleshooting articles.
Hello all,
Trying to figure out where or how to change ALS configuration on the touch pad from Front Injector to Back Injector and vice- versa?
Thanks,
Ting
Hi,
You can configure from touch screen by going in setting option.
Hi - thanks but there is no ALS option at the set up
Hi - thanks but there is no ALS option at the set up
Can you check ALS Led is light up or not.If wire of ALS is connected properly with GC from back side then after restarting the instrument, ALS should show in setting then service mode then set up..
ALS is stuck on Front Injector on the panel and on the GC. I need it to register as the Back Injector. Have tried both connections in the back, have rebooted multiple times - no success. In the 6890 - we were able to have the flexibility to choose Inj1 or Inj2 as front or back . I can't seem to find a way on these new fancy touch screens :)
What you are finding in inlet in above pic..can you share pic after clicking inlet..
And also share pic of led light of ALS to understand the problem..
ALS works fine as Front Injector - wire and connection is not the issue. thanks