Problème répétabilité

Bonjour Agilent,

Je travaille sur  dosage de l'éthanol (en pourcentage v / v) sur GC Agilent 8860. J'ai fait une droite d'étalonnage de 10% à 100% et j'ai obtenu un r² = 0.9968, jusqu'ici aucun problème. Puis, j'ai voulu passer des échantillons inconnus, lorsque je passe 3 fois la même solution j'obtiens 3 valeurs qui varient énormément (pouvant aller de 50% à 150%), je n'ai donc aucune répétabilité et je ne retrouve pas les bonnes valeurs. Avez-vous une idée d'où cela peut venir? Merci d'avance, CL

Parents
  • Translation below: The Agilent Forum can be set to your local language in settings

    Hello Agilent,

    I am working on ethanol assay (in percentage v / v) on Agilent 8860 GC.
    I made a calibration line of 10% to 100% and I got an r² = 0.9968, so far no problem .
    Then, I wanted to pass unknown samples, when I run the same solution 3 times I get 3 values ​​which vary enormously (which can range from 50% to 150%),
    so I have no repeatability and I cannot find the right values. Do you have any idea where this might come from? Thanks in advance, CL
Reply
  • Translation below: The Agilent Forum can be set to your local language in settings

    Hello Agilent,

    I am working on ethanol assay (in percentage v / v) on Agilent 8860 GC.
    I made a calibration line of 10% to 100% and I got an r² = 0.9968, so far no problem .
    Then, I wanted to pass unknown samples, when I run the same solution 3 times I get 3 values ​​which vary enormously (which can range from 50% to 150%),
    so I have no repeatability and I cannot find the right values. Do you have any idea where this might come from? Thanks in advance, CL
Children
No Data
Was this helpful?