Calibration Standard Rack Position on MP Expert

Question

Hi there, 
 Is it possible to change the position of calibration standards in MP Expert for MP-AES on an SPS4 autosampler. 
 Specifically, 1. Can I place calibration standards onto a sample rack or 2. Can I select positions other than sequentially increasing after starting at 1 on the standard rack? 
 
 The option to change rack and tube position on the sequence or standards tabs don't seem to allow changes.

Tom Herzog · Answer

As of MPExpert1.6.2 (the most recent version) it is not possible to change the tube position of calibration standards.

edgarvs · Answer

Hi, 
 it's possible to change the starting point of the calibration standards, but not in the sequence page. 
 Hoover over the autosampler racks in the 'Autosampler' tab. Right mouse klik on the preferred starting tube and preferred rack use. Select the 'Rack Use' and 'Set Start Tube' like you want. 
 this give a bit more flexibility.

good luck with you measurements, 
 
 Edgar