Hi!
There is a task to analyze multiple elements in some samples. But not for each sample we need to measure all elements that are set in the Batch. Is there a possibility to program the Batch so that for each sample we could choose data for which elements should be acquired? Because if we create several batches for this task, we will need to perform repeated calibrations. So, as well as measuring additional elements in samples the repeated calibration will be waste of time and consumables. We have MassHunter ver. D.01.01.
For examle, we need to measure Na, Mg, Al, K, Ca, Ti, Mn, Fe, but
in sample #1 we need only Na, Mg, Al, K,
in sample #2 Mg, Al, K, Ca,
in sample #3 K, Ca, Ti, Mn, Fe,
in sample #4 Na, Mg, Al, K, Ca, Ti, Mn, Fe.
Kind regards,
Volodymyr
