Atomic Spectroscopy

Forum TUNING HMI IN ICP/MS 7900

TUNING HMI IN ICP/MS 7900

Onil19 over 1 year ago

Hello, I have a query about what criteria are used to approve the tuning in HMI Non-gas mode in ICP/MS 7900?

Top Replies

cschulz over 1 year ago +1

Hi, actually, there are no official criteria defined by agilent. The autotune will try to max the counts. Maybe you have to adjust the concentration of your tune solution, because 1ppb will not give…

Parents

0 cschulz over 1 year ago

Hi,

actually, there are no official criteria defined by agilent. The autotune will try to max the counts.

Maybe you have to adjust the concentration of your tune solution, because 1ppb will not give enough counts to do an autotune.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 cschulz over 1 year ago

Hi,

actually, there are no official criteria defined by agilent. The autotune will try to max the counts.

Maybe you have to adjust the concentration of your tune solution, because 1ppb will not give enough counts to do an autotune.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

Was this helpful?