Full spectrum on startup

This is contamination in tune solution, so change tune solution with freshly prepared. If the problem not solved check the initial tune.

Hi elementallab, 

I would be surprised if this was contamination in the tune solution, we use the agilent 10ug/L Ce, Tl, Y,Co and Li tune solution. 

This is our settings for start up, but it does not allow me to change the solution at the tune/ISTD column, is there any way I can do it elsewhere? Or could I select full spectrum only and use autosampler position in the top bar? 

Hi elementallab, 

I would be surprised if this was contamination in the tune solution, we use the agilent 10ug/L Ce, Tl, Y,Co and Li tune solution. 

This is our settings for start up, but it does not allow me to change the solution at the tune/ISTD column, is there any way I can do it elsewhere? Or could I select full spectrum only and use autosampler position in the top bar? 

Hi,

 Probably  it was not clear in previous message. I see now that you use ISIS, so contamination could be somewhere in capillarity tube or valve – to check this you can test tune like sample in other vial  in auto sampler and look in signal monitor for problematic masses counts.

Regards,