Hello,
My performance report is gret. I set AutoTune before my batch. But it fails everytime. It says low sensitivity (No gas mode)
Find maintenance, best practice, and troubleshooting articles.
Hello,
My performance report is gret. I set AutoTune before my batch. But it fails everytime. It says low sensitivity (No gas mode)
Hello,
Please ensure the correct tune vial is selected and enough sample uptake/stabilization time is given in your Batch. This is in in Acq Method->PeriPump
I appreciate for your help.
How do you set preemptive Rinse?
I appreciate for your help.
How do you set preemptive Rinse?
The check box to enable this is on the bottom right of the same page. Pre-emptive rinse allows the user to select a pre meditated time before the end of the current acquisition to move the probe from sample to rinse solution, to speed up analysis time
Thank you so much!