Script needed 96 to 384

Question

I am needing a script on a bravo that would pipette from a 96 plate to 384 plate. It would need to Combine for 96 plates and one 384 plate. Software is Vworks.

eugene · Accepted Answer

Hi Znaima 
 This menu options is specific to dispense task only when it is presented inside a loop. see picture bellow. once I put in loops I get this menu. 
 
 If you would like to learn more about looping, check this link in VWorks knowledge base. 
 http://www.velocity11.com/techdocs/AutomationSolutionsKB13/wwhelp/wwhimpl/js/html/wwhelp.htm#href=vworks4_ug/09_Scheduling.13.07.html 
 this link for defining the plate. 
 http://www.velocity11.com/techdocs/AutomationSolutionsKB13/wwhelp/wwhimpl/js/html/wwhelp.htm#href=vworks4_ug/09_Scheduling.13.02.html 
 KB has a lot of information. 
 Let me know if you have any questions. 
 Regards 
 Eugene

eugene · Answer

Hello Znaima, 
 Are you trying to combine four(4) 96 plates into one(1) 384 plate? 
 There is different ways of writing the script because there is many variables. 
 Here is a screen shot of a simple protocol which has 4 source plates(96) asperate and dispense into 4 different quadrants of the 384ST plate. 
 There is many other variables not taken into consideration like changing tips after each dispense, volume of each transfer, plate definition and pipetting speeds 
 Please review the information and let us know if you have any questions. if you would like Agilent to develop this protocol for you please contact us at service.automation@agilent.com 
 Regards. 
 Yevgeniy.

Script needed 96 to 384

Top Replies