AVS 6/7 Tubing Connections and Part Numbers

This Information Applies To: Agilent 5000 Series ICP-OES, AVS 6/7

Issue

This article shows the required tubing connections and part numbers between the AVS 6/7 and ICP-OES

ICP-OES sample introduction system:

Figure 1. Sample introduction system and AVS 7 (shown as 1)

Figure 2. Connections to AVS:  1 to AVS Pump, 2 from Autosampler probe (rinse), 3 Argon gas, 4 Rinse/Carrier

Figure 3. AVS (showing tubing removed): (A)  AVS valve, (B) Sample loop holder, (C) AVS pump inlet, (D) AVS pump outlet, (E) Bubble injector

Table 1 shows connections points to AVS valve and part numbers of tubing

Table 1. AVS connections

Figure 4. AVS (showing tubing connected): (A) to Nebulizer, (B) to Autosampler, (C) to Internal Standard (AVS 7 only), (D) to AVS pump inlet, (E) to Rinse/Carrier

Tip: Refer to the Help section of the Agilent ICP Expert Instrument Software for full details of tubing connection points and parts required

After replacing all required components, perform the Advanced Valve System Test as detailed in the Help section of the Agilent ICP Expert Instrument Software to check performance of the AVS.

Learn how to effectively maintain your Agilent AVS:  Agilent 5000 Series ICP-OES with ICP Expert e-learning path available from Agilent education