Another calibration report for OpenLAB CDS ChemStation

Document created by agilent Employee on Mar 11, 2016Last modified by agilent Employee on Mar 11, 2016
Version 4Show Document
  • View in full screen mode

The attached template generates a calibration/sample report to be used with OpenLAB CDS ChemStation A.01.04 or higher. It shows:

 

  • Calibration curves of all compounds calibrated at t1
    • All samples analyzed with this calibration version t1
  • Calibration curves of all compounds calibrated at t2
    • All samples analyzed with this calibration version t2
  • Calibration curves of all compounds calibrated at t3
    • All samples analyzed with this calibration version t3
  • and so on ....

 

Note:  This template works with sample type "Sample" only.  Calibration runs are filtered out, because intermediate recalibration states are not of special interest. Since calibration information is stored with every sample run, these run types should be reported to show the relevant calibration curves only.

 

(originally posted in OpenLAB Forum: https://zohodiscussions.com/openlabcdsforum#Topic/68030000000043019

2012 September 21

by Bern... E.)

Outcomes