• "Roughing, System Pressure Wait" Pumps wont work

    I have a Varion 979 now Agilent.  I have the pumps DS 302 and SD-451 attached.   When I turn on the unit the roughing pump usually starts as the unit warms up.  Today the roughing pump did not start sc...
    kadams_jetseal
    last modified by kadams_jetseal
  • Collection of Vacuum Resources

    Here is a "best of" collection of links to manuals, tools, and other resources for Agilent Vacuum products. For other instruments refer to Collection of Support Resources.     Collection of Vacuum Resource...
    jwittmer
    last modified by brianmess
  • Does anyone have a manual for a Varian IG-10 Ion Gauge Controller?

    I recently bought a Varian IG-10 Ion Gauge controller and do not have a manual of even a pin-out listing.  I do not have a cable for it either so I need to at least know the pin-outs to connect it to my ion gauge...
    aviescas
    last modified by aviescas
  • Varian 979: "turbo not ready"

    The turbo pump on a Varian 979 leak detector seems to not be working.  The fuse is fine.  In the "System Info" menu, it displays "TURBO NOT READY".  I can not find any explanation or troubleshooting adv...
    e2pco
    last modified by e2pco
  • leak rate conversion

    We use VARIAN VS Series helium mass spectrometer leak detectors (MODEL MR15). This detector shows leak rate by atm*cc/s but we want to know the leak rate by ppmv.   So, could you give us the "total gas flow rat...
    dhsuh
    last modified by dhsuh
  • Can I turn off the filament of a Varian 979 leak detector?

    I want to use a Varian 979 as a pumping station to pump-clean a cold head. The cold head was filled with pure He4, so the leak rate would overload. Can I turn off the filament of the mass spectrometer to prevent overl...
    isend
    last modified by isend